Training wheels for geared bikes (20" Large, 24", 26")
Have a set of training wheels for your geared bike? Watch this video to get the installation done just right!. This is just for our 20" large, 24" and 26" bikes!.
All articles
Accessories
Get help with helmet fit, training wheel installation, bottle cages and more
Training wheels single speed bikes (14", 16" and 20" small)
Follow this setup video for help installing training wheels on you 14/16/20"S bike. If your bike was purchased before July 30 2024, please go here: Older model training wheels (Wald).
Helmet Fitting
Now that you’ve purchased the right helmet, it’s time to get it fastened on properly. This is where many parents make mistakes, so read carefully:.
Water bottle holder installation
How to install a water bottle holder on any size bike.
Install new grips
1. Slide or cut off the current grips from both sides. A flathead screwdriver will help remove the grips. Inset screwdriver and twist the grip back and forth while pulling it off. 2. Spray a small amount of hairspray (optional, but recommended) into
Seat clamp
Steps. 1. Open lever on existing seat clamp. 2. Loosen nut until the clamp comes off. 3. Open up the lever on new seat clamp. 4. Loosen the nut on new seat clamp. 5. Place it on the top of seat tube so that the lever is on the chain side and the nut
Bike locks
To set up your lock, first make sure it's set to 00000, then rotate the knob 90 degrees clockwise. Then, set your combination number, rotate the knob again, this time 90 degrees counter-clockwise. Follow the same steps to unlock and lock your bike.
Install a bike bell
Ding ding! Check out this video to see how to install your bike bell. For 12" balance bikes and 14" bikes, make sure to locate the foam shims included with your bell for snug installation.
Why doesn't my bell fit on the handlebar?
To ensure your bell fits securely on your 12" balance bikes and 14" bikes, we include shims with your purchase. Here’s what you need to know:. When to Use Shims: If your bell feels loose when installed, you'll need to use the shims provided. These sh
How to use the bike hand pump
Please note the pump can only be installed directly on the 24 and 26 inch frames. Smaller bikes do not have enough room on the frame for the pump to attach directly. To remove the nuts on the frame, you'll unscrew them counterclockwise with a 4 mm al
Streamers
See here how to install streamers on the handlebar!